FCB HD 10 LV

INPUTS:

DATA 4 LINK LVDS (from Sony FCB-H10)
CLOCK LVDS (from Sony FCB-H10)
CAMERA RESET LVTTL
CONTROL Rx RS232 fromCamera TTL-Level

OUTPUTS:

CONTROL Tx RS232 to Camera TTL-Level
VIDEO (HD MODE) HD-SDI, 1080i or 720p, 59.94Hz or 50Hz
analog Y, Pb, Pr (direct from camera)
VIDEO (SD MODE) CVBS (direct from camera)

POWER INPUT:

7V TO 12V regulated, 8V recommended
6 Watts (FOR BOTH, CAMERA AND MODULE, CAMERA in HD
mode)

OPERATING CONDITIONS:

Ambient Temperature (min/max): +5°C/+45°C = 41°F/11 3°F
Humidity: 20%-70%

STORAGE CONDITIONS:

Temperature (min/max): 0°C/+50°C = 32°F/122°F
Humidity: 20%-80%

BOARD MECHANICAL:

WIDTH = 44mm
HEIGHT = 42mm
THICKNESS = 1.59mm

CONNECTOR PIN ASSIGNMENTS:

J4 Power input connector:

Pin 1 = +8V DC typ. (7V to 12V range allowed)
Pin 2 = NC (open)
Pin 3 = GND

J5 Signal and Control connector:

Pin 1 = RXD (serial data from Host to Camera) RS232-Level
Pin 2 = TXD (serial data from Camera to Host) RS232-Level
Pin 3 = RESET IN (Reset to Camera) TTL
Pin 4 = CVBS OUT (available only in SD camera mode)
Pin 5 = GND
Pin 6 = Y component OUT (available only in HD camera mode)
Pin 7 = CB component OUT (available only in HD camera mode)
Pin 8 = CR component OUT (available only in HD camera mode)

CABLES:

*FFC flex cable, 0.5 mm spacing, 24 wires, length = 60mm**
Contacts on opposite sides
MOLEX Premo-FlexTM type numbers (for reference only)
21020-0256 (America type D jumpers)
98266-0256 (Europe type D jumpers)
* Micro coaxial cable is KEL SSL20-10SSB-010-B type ,
length = 100mm**
* Power connector housing is JST SHR-03V-S with 2x SSH-003TP0.2-
H (crimp contact) and AWG28-AWG32 cable
* Signal connector housing is JST SHR-08V-S with 8x SSH-003TP0.2-
H (crimp contact) and 150mm AWG28-AWG32 cable

Notes:
* supplied with module, can be ordered as cable kit separately
** Other cable length available on request